coreldraw & ramcam to import
-
- Posts: 1
- Joined: Fri Dec 30, 2016 5:12 pm
- Location: RED BLUFF, CA
- Contact:
coreldraw & ramcam to import
I am a Coreldraw user (x6) and I just downloaded RAYCAM. I am trying to import CORELDRAW files into Raycam and Raycam wont recognize them. What do I need to do to make this work?. I've used the computers and machines at L.O. Hq and there is a shortcut tab (top tool menus line) in their computer that jumps from Coreldraw to Raycam. What do I need to do to succeed?
-
- Posts: 4649
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
Re: coreldraw & ramcam to import
Run the RayCam installation program and select CorelDraw add on module. Select the version and point to the correct path and that should take care it for you
Marco
Marco
-
- Posts: 26
- Joined: Sat Feb 18, 2017 10:54 am
- Contact:
Re: coreldraw & ramcam to import
I am trying to install the RayCAM plugin for CorelDraw X8 and after choosing the right version and directory it keeps comming back with directory not found. I have tried every combination I can think of with the same results.
Any suggestions?
Thanks
David
Any suggestions?
Thanks
David
-
- Posts: 4649
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
Re: coreldraw & ramcam to import
So far both RayCam or LaserCad supports CorelDraw up to version 7.0 only
Will discuss with the programmer soon about the issue
Marco
Will discuss with the programmer soon about the issue
Marco
-
- Posts: 26
- Joined: Sat Feb 18, 2017 10:54 am
- Contact:
Re: coreldraw & ramcam to import
Ok, thanks Marco
-
- Posts: 26
- Joined: Sat Feb 18, 2017 10:54 am
- Contact:
Re: coreldraw & ramcam to import
Does the plugin only work with the full version of the Coreldraw X7 or will it work with the Home and Student version? Just wanted to check before I buy.
Thanks
David
Thanks
David
-
- Posts: 26
- Joined: Sat Feb 18, 2017 10:54 am
- Contact:
Re: coreldraw & ramcam to import
I think I have answered my own question and the answer is it requires the full version to get macro support.
David
David
Who is online
Users browsing this forum: No registered users and 8 guests