Can the X7 autofocus while its running an engraving operation ?
Provided it has the inductive sensor and z table
LO-X7 autofocus while engraving
-
geartech
- Posts: 29
- Joined: Fri Sep 25, 2015 5:56 pm
- Contact:
-
Techgraphix
- Posts: 492
- Joined: Fri Jan 20, 2012 1:39 pm
- Location: Appelscha, the Netherlands
- Contact:
Re: LO-X7 autofocus while engraving
Without any extra's: NO..
But if you want to spend a little fortune you could try the dynamic autofocus system, although i think it will be too slow for engraving @300mm/sec
When engraving the surface should be flat (within DOF-range) and horizontal.. Then you only need to autofocus once..
Kees
But if you want to spend a little fortune you could try the dynamic autofocus system, although i think it will be too slow for engraving @300mm/sec
When engraving the surface should be flat (within DOF-range) and horizontal.. Then you only need to autofocus once..
Kees
Who is online
Users browsing this forum: No registered users and 4 guests