parameter settings dsp display and thru lasercad.

[paulburzynski]

When you make a change to one of the machine parameters thru
Lasercad and click" save", do the same parameters change on the dsp display or do you have to enter those indipendently? I noticed the "apply" key is not functional? Is that mormal?

Thank you!

[Tech_Marco]

After Save, you need to 'Reset' the DSP by press the "Reset" button on the DSP or on LaserCAd


Marco

[paulburzynski]

The datum button on laser cad is the reset button?l

[Tech_Marco]

Yes. Or, the "RESET" button on the LCD panel

[paulburzynski]

I'm able to jog the gantry from both the computer and the lcd panel.but I still get an error message when I try to send the cut file to the dsp or when I copy it to the thumbnail drive and then try to run it..although a preview shoshone up on the lcd when using the thumb drive.. when I try to cut the file I get the error message. I will email you some screen shots so you can look at the error messages and the machine settings.

Thanks.