Engraving setting questions.
-
trent
- Posts: 8
- Joined: Thu Jul 26, 2012 5:28 pm
- Contact:
Engraving setting questions.
I have been trying to engrave an image. it was fairly low les and I stretched it out but when engraved it was scanned like this. each line is lased several times. Why is it doing this and can I change the over burn.
- Attachments
-
- while doing this engraving this started showing after about an hour.
- IMG_0051.jpg (80.26 KiB) Viewed 1778 times
-
- each line is lased several limes before moving to the next.
- IMG_0052.jpg (76.14 KiB) Viewed 1778 times
-
70cyclone
- Posts: 7
- Joined: Thu Nov 08, 2012 3:35 pm
- Contact:
Re: Engraving setting questions.
I have the same issue. It runs a couple passes over the same spot then jumps, runs a couple passes over the same spot, etc.
Cutting seems to be on size and repeatable, but any engraving I do gives these results.
Cutting seems to be on size and repeatable, but any engraving I do gives these results.
-
70cyclone
- Posts: 7
- Joined: Thu Nov 08, 2012 3:35 pm
- Contact:
Re: Engraving setting questions.
well it seems you have to turn off BMP optimize in the engrave settings, seems to work for me now.
Who is online
Users browsing this forum: No registered users and 2 guests