X7 DSP upgrade kit for D/K40

[clivegriffiths]

Has anyone got step by step instructions for carrying out this upgrade?

[Tech_Marco]

User Step by Step procedure I posted one the form (under Manual Download). Even though it was using AWC60 as the controller, the procedure is similar

Marco

[mikenmel08]

Can anyone tell me the size of the back of the X7 controller? I would like to start on my Installation panel.....

Thanks
Mike

[fnaranjob]

Can anyone tell me the size of the back of the X7 controller? I would like to start on my Installation panel.....

Thanks
Mike

Dear Marco,

I'd like to know the dimensions too please, I'd rather start making the panel for the machines I'm building now and not wait until the DSPs arrive.

Thank you

[MitchL]

Here are the dimensions I used for my AWC708 panel. It was a little tight (the 708C wants to "clip" in) but it worked.

I installed mine in 22ga steel.

Interesting note: this opening is also well sized for an AWC608 if you use my 3D printed bezel (model is in the forum here somewhere).

/Mitch.

The opening shown here is rotated 90 degrees, it was taken from the drawing of one of my machine's skins.

AWC708 opening

AWC708Opening.PNG (14.13 KiB) Viewed 2938 times

[fnaranjob]

Here are the dimensions I used for my AWC708 panel. It was a little tight (the 708C wants to "clip" in) but it worked.

I installed mine in 22ga steel.

Interesting note: this opening is also well sized for an AWC608 if you use my 3D printed bezel (model is in the forum here somewhere).

/Mitch.

The opening shown here is rotated 90 degrees, it was taken from the drawing of one of my machine's skins.

AWC708Opening.PNG

Thank you very much!

Fernando

[fnaranjob]

Here are the dimensions I used for my AWC708 panel. It was a little tight (the 708C wants to "clip" in) but it worked.

I installed mine in 22ga steel.

Interesting note: this opening is also well sized for an AWC608 if you use my 3D printed bezel (model is in the forum here somewhere).

/Mitch.

The opening shown here is rotated 90 degrees, it was taken from the drawing of one of my machine's skins.

AWC708Opening.PNG

Hi Mitch,

If it's not too much trouble, could you please help me with a drawing of the outline of the X7 DSP together with the hole in the panel?, I'm making some decals and labels and that helps me position the components on the panel correctly.

Thank you
Fernando