Lightobject.com Support Forum

Hi all
I wondering how I can safe the file after it worked out with the acuracy what I need because I try this to safe it on my harddrive but when I reload it failure m,essage comes up that the file can not be loaded if I safe it in the LCD and recall it after same other work is done the measuremnets or complete off before I recall it I hit the resett botton and the machine goersw in the home position no problem
what do I do wrong?
greetings
walt

hi all and marco
did anybody ever try to safe a file from the DSP to a USB stick over the U file USB connector on the new DSP controller?
I try this many times but it allways ends up with the message "coppy error"
a similar probleme exist sometimes after saving a work file on my HD out of laser cut 5.5 and try to reload it to laser cut there comes the message " a unknown erroro occured the program shuts down" its not allways but also with different files.
what is this " U file" system good for and the U file connector if it does not work??
especially if you have a file with the right settings in the working and you can not save it from the DSP.
maybe this is another probleme with the software I dont know, maybe somebody else has figured it out
please let me know

greetings
walt

Hello:

I have chat with the programmer and showed him the problem. He said that he would work out an upgrade patch to solve that issue.

Problem: Can't save file from the main board (through LCD panel) to a memory stick (dump drive)

Solution: Working on a patch to solve this issue.

Alternative: Save the job file to PC and then copy the file from PC to the dump drive will work


Marco

hallo marco,
first thanks! I try this saved the file from my hardrive to the USB stick and inserted the USB stick in the DSP but if I try to open it it says " no Udrive" .
just that he looks in to it too.
greetings
walt

Tech_Marco wrote:Hello:

I have chat with the programmer and showed him the problem. He said that he would work out an upgrade patch to solve that issue.

Problem: Can't save file from the main board (through LCD panel) to a memory stick (dump drive)

Solution: Working on a patch to solve this issue.

Alternative: Save the job file to PC and then copy the file from PC to the dump drive will work


Marco

Try to format the memory stick wiht FAT32 and try again
Also, do clean up on the main unit then cycle off the power and try again

Marco

hi marco
I did all of this already a few times I also format the memory in DSp nothing changed except that I lost all my files what was in ther allready.
greetings
walt

Tech_Marco wrote:Try to format the memory stick wiht FAT32 and try again
Also, do clean up on the main unit then cycle off the power and try again

Marco