Page 1 of 1
Return home after job
Posted: Thu Jun 30, 2016 11:50 pm
by seeigecannon
Is there any setting that I can change that will make the laser return to its home position after it has finished doing its job? Right now it just returns to whatever corner I started the job at, but I would prefer it move out of the way completely on its own. Thoughts?
Re: Return home after job
Posted: Fri Jul 01, 2016 12:58 pm
by jhuangupp
Please do this in the LCD control panel:
Menu->common parameters setting-> work mode->go back position ->zero coordinate.
Re: Return home after job
Posted: Fri Jul 01, 2016 8:23 pm
by seeigecannon
jhuangupp wrote:Please do this in the LCD control panel:
Menu->common parameters setting-> work mode->go back position ->zero coordinate.
Is that for the AWC-608? I don't remember seeing a settings like that.
Re: Return home after job
Posted: Thu Jul 07, 2016 2:59 pm
by jhuangupp
Th feature is currently available to X7 DSP controller.