Daughter board for Lo-R5 DSP conversion
Posted: Fri Oct 09, 2015 4:50 pm
Doing a install of the LO R5 DSP thought i would make it easier to go back some times I break things. 
Put in a a couple of PNP transistors and 5v relays, so the DSP thinks it is has NC limits but still using the original ones.
Most of the stuff I already had except the FFC connector. The green connectors are over kill and probably need double the 24v/GND connections.
Darn top print moved when I was putting it on.
Put in a a couple of PNP transistors and 5v relays, so the DSP thinks it is has NC limits but still using the original ones.
Most of the stuff I already had except the FFC connector. The green connectors are over kill and probably need double the 24v/GND connections.
Darn top print moved when I was putting it on.
- DaughterBoard.png (12.68 KiB) Viewed 1222 times