Page 1 of 1
Setting home to 0 in centre of table -SOLVED
Posted: Mon Jun 29, 2015 3:20 pm
by funhawke
In LaserCad is there a way to set where home will be. Still having problems with the table going to far on x and y but when I monkey with it - it seems to always put "0" in the centre of the table?
Re: Setting home to 0 in centre of table
Posted: Mon Jun 29, 2015 4:06 pm
by Tech_Marco
Are you talking about "HOME"(where limit switches is installed) or "Origin" where laser head start to do job at?
You can set HOME at one of the corner; Top Left,Top Right, Bottom Left, and Bottom Right.
For Origin, you press "Origin" on LCD control panel to set the location of the origin
Marco
Re: Setting home to 0 in centre of table
Posted: Tue Jun 30, 2015 6:15 am
by funhawke
Thanks Marco - that is exactly what I was looking for. Home and Origin