Page 1 of 1
X7 DSP upgrade kit for D/K40
Posted: Fri Jan 16, 2015 10:56 am
by clivegriffiths
Has anyone got step by step instructions for carrying out this upgrade?
Re: X7 DSP upgrade kit for D/K40
Posted: Fri Jan 16, 2015 11:35 am
by Tech_Marco
User Step by Step procedure I posted one the form (under Manual Download). Even though it was using AWC60 as the controller, the procedure is similar
Marco
Re: X7 DSP upgrade kit for D/K40
Posted: Sat Jan 17, 2015 3:39 pm
by mikenmel08
Can anyone tell me the size of the back of the X7 controller? I would like to start on my Installation panel.....
Thanks
Mike
Re: X7 DSP upgrade kit for D/K40
Posted: Sat Jan 17, 2015 3:48 pm
by fnaranjob
mikenmel08 wrote:Can anyone tell me the size of the back of the X7 controller? I would like to start on my Installation panel.....
Thanks
Mike
Dear Marco,
I'd like to know the dimensions too please, I'd rather start making the panel for the machines I'm building now and not wait until the DSPs arrive.
Thank you
Re: X7 DSP upgrade kit for D/K40
Posted: Sat Jan 17, 2015 4:47 pm
by MitchL
Here are the dimensions I used for my AWC708 panel. It was a little tight (the 708C wants to "clip" in) but it worked.
I installed mine in 22ga steel.
Interesting note: this opening is also well sized for an AWC608 if you use my 3D printed bezel (model is in the forum here somewhere).
/Mitch.
The opening shown here is rotated 90 degrees, it was taken from the drawing of one of my machine's skins.
- AWC708 opening
- AWC708Opening.PNG (14.13 KiB) Viewed 2940 times
Re: X7 DSP upgrade kit for D/K40
Posted: Wed Jan 21, 2015 12:40 pm
by fnaranjob
MitchL wrote:Here are the dimensions I used for my AWC708 panel. It was a little tight (the 708C wants to "clip" in) but it worked.
I installed mine in 22ga steel.
Interesting note: this opening is also well sized for an AWC608 if you use my 3D printed bezel (model is in the forum here somewhere).
/Mitch.
The opening shown here is rotated 90 degrees, it was taken from the drawing of one of my machine's skins.
AWC708Opening.PNG
Thank you very much!
Fernando
Re: X7 DSP upgrade kit for D/K40
Posted: Fri Jan 23, 2015 12:34 pm
by fnaranjob
MitchL wrote:Here are the dimensions I used for my AWC708 panel. It was a little tight (the 708C wants to "clip" in) but it worked.
I installed mine in 22ga steel.
Interesting note: this opening is also well sized for an AWC608 if you use my 3D printed bezel (model is in the forum here somewhere).
/Mitch.
The opening shown here is rotated 90 degrees, it was taken from the drawing of one of my machine's skins.
AWC708Opening.PNG
Hi Mitch,
If it's not too much trouble, could you please help me with a drawing of the outline of the X7 DSP together with the hole in the panel?, I'm making some decals and labels and that helps me position the components on the panel correctly.
Thank you
Fernando