Page 1 of 1
Engraving setting questions.
Posted: Sun Jan 04, 2015 9:19 pm
by trent
I have been trying to engrave an image. it was fairly low les and I stretched it out but when engraved it was scanned like this. each line is lased several times. Why is it doing this and can I change the over burn.
Re: Engraving setting questions.
Posted: Sun Feb 08, 2015 11:21 am
by 70cyclone
I have the same issue. It runs a couple passes over the same spot then jumps, runs a couple passes over the same spot, etc.
Cutting seems to be on size and repeatable, but any engraving I do gives these results.
Re: Engraving setting questions.
Posted: Wed Mar 11, 2015 1:57 pm
by 70cyclone
well it seems you have to turn off BMP optimize in the engrave settings, seems to work for me now.