Page 1 of 1
Setting up power z. Problems with wiring
Posted: Sun Aug 10, 2014 9:41 am
by dholzric
I'm trying to install a power z table tinto a kt-3020 but i'm not sure of the connections. I have the SC-04 and an M415b driver. Does anyone have a schematic or could you tell me the connections from teh sc04 to the driver? The pulse and direction match up but i'm not sure which other wires to connect.
Thanks,
Dan
Re: Setting up power z. Problems with wiring
Posted: Tue Aug 12, 2014 11:30 am
by Tech_Marco
Give me a moment to make the connection diagram
Marco
Re: Setting up power z. Problems with wiring
Posted: Wed Aug 13, 2014 7:48 am
by dholzric
Thanks Marco. Are you going to post it in this thread?
Tech_Marco wrote:Give me a moment to make the connection diagram
Marco
Re: Setting up power z. Problems with wiring
Posted: Wed Aug 13, 2014 1:03 pm
by Tech_Marco
As matter of fact, I did created the diagram and posted it a while ago:
viewtopic.php?f=16&t=1493
2M415 or M415B are the same from different provider
"Opto" = +5V
Marco
Re: Setting up power z. Problems with wiring
Posted: Wed Aug 13, 2014 8:01 pm
by dholzric
Thanks! I have it working now.
Tech_Marco wrote:As matter of fact, I did created the diagram and posted it a while ago:
viewtopic.php?f=16&t=1493
2M415 or M415B are the same from different provider
"Opto" = +5V
Marco