solution for changing speed or power during run
Posted: Wed Oct 16, 2013 7:35 am
Hi all
I always was mad if I start a job and something the speed or power setting was not right, I guess everybody knows this.
here the solution:
during run select on the display with the arrows what you wana change ( ether speed or power) then press enter on the submenu change with the arrows to the new setting and press enter again and... the new setting is in effect.
greetings
waltfl
I always was mad if I start a job and something the speed or power setting was not right, I guess everybody knows this.
here the solution:
during run select on the display with the arrows what you wana change ( ether speed or power) then press enter on the submenu change with the arrows to the new setting and press enter again and... the new setting is in effect.
greetings
waltfl