Page 1 of 1
U axis for rotary?
Posted: Mon Oct 29, 2012 6:31 am
by Telrad
Is it possible to use the U axis for rotary engraving? I have more than enough motor controllers in my setup and it would be very convenient. I wouldn't have to keep switching motors or wires to make it work.
Re: U axis for rotary?
Posted: Wed Oct 31, 2012 2:26 am
by Greolt
I am replying, not because I have a good answer for you, but nobody else has.
No you can not use the U axis for rotary, only X or Y. With Y swapped to A, being the most common configuration.
Greolt
Re: U axis for rotary?
Posted: Sat Nov 03, 2012 7:20 pm
by Telrad
That stinks.
Re: U axis for rotary?
Posted: Sun Nov 04, 2012 3:21 am
by waltfl
Hi there
now I am baffled because the Z is for a lift table and the U is for rotary acessory in acordance with the manual of the AW608
if there is something new???
greetings
walt
Greolt wrote:I am replying, not because I have a good answer for you, but nobody else has.
No you can not use the U axis for rotary, only X or Y. With Y swapped to A, being the most common configuration.
Greolt