Page 2 of 2
Re: Overcut in LaserCAD
Posted: Wed Mar 07, 2012 3:24 pm
by Tech_Marco
"Overlap does not work in combination with lead ins and outs."
Where did you find the setting of "lead ins and outs"?
If I enabled "Line_Cut_mode", mine won't do the over-cut as I test so many times.
Marco
Re: Overcut in LaserCAD
Posted: Wed Mar 07, 2012 5:05 pm
by Greolt
Tech_Marco wrote:
Where did you find the setting of "lead ins and outs"?
When I tested yesterday, overlap worked with "Line_Cut_mode"
I will retest today. See if I made a mistake.
Greolt
Re: Overcut in LaserCAD
Posted: Wed Mar 07, 2012 5:29 pm
by Tech_Marco
Thanks, let me talk to Li about it
Marco
Re: Overcut in LaserCAD
Posted: Wed Mar 07, 2012 6:33 pm
by Greolt
Greolt wrote:
When I tested yesterday, overlap worked with "Line_Cut_mode"
I will retest today. See if I made a mistake.
I retested. Cut a simple circle with 3mm overlap set.
Tried with "Line_Cut_mode" set and not set.
Overlap definitely happened in both instances.