Can someone please explain the pinout pattern of the thermocouple (thermistor in this case) inlet of the JLD612? The PT-100 has three spade terminals, two blue and one red. The JLD612 shows pins 8,9 and 10 involved. From the label I infer that 9 and 10 get a blue (showing + & -, and resistors are not sensitive to polarity) and the red goes to 8, signified by an "R" in the schematic label. Before I hook this up, can someone please confirm my suspicions? If I'm wrong, correction is encouraged!
Thanks,
Dave
PT-100 and JLD612 question
-
soopirV900
- Posts: 4
- Joined: Mon May 17, 2010 5:23 pm
- Contact:
-
tonylange
- Posts: 5
- Joined: Tue Oct 05, 2010 7:10 pm
- Contact:
Re: PT-100 and JLD612 question
Hi Dave, just had the same. You wont bust the controller. just use the two red ones as the + - and the odd as the common. T
Who is online
Users browsing this forum: No registered users and 0 guests