Ink Scape with DSP
-
davem506
- Posts: 1
- Joined: Fri Nov 08, 2013 6:26 pm
- Contact:
Ink Scape with DSP
Will Ink Scape work much like Coreldraw when using the DSP?
-
baccus61
- Posts: 288
- Joined: Sun May 23, 2010 6:40 pm
- Location: Broken Hill, NSW, Australia
- Contact:
Re: Ink Scape with DSP
One user on CNCZone has set up InkScape with MosheDraw and it worked ok but I don't know if it will work with LaserCad. Apparently Moshe is crap but you would have to Ask Marco if it is compatible with LaserCad.
I don't know if it will work as a stand alone program as I have never tried it like that.
Rich.
I don't know if it will work as a stand alone program as I have never tried it like that.
Rich.
-
swamidog
- Posts: 59
- Joined: Mon Feb 03, 2014 3:28 pm
- Contact:
Re: Ink Scape with DSP
i had no problems tracing bitmaps with inkscape and exporting as dxf for lasercad, but i was unable to try talking directly to the dsp with it as it was running on a different machine.davem506 wrote:Will Ink Scape work much like Coreldraw when using the DSP?
Who is online
Users browsing this forum: No registered users and 6 guests