It would be nice if a person wanted to order a power supply to see how easy or hard it would be to wire it up to the laser tube and variouse power activation choices. I have looked on the forums but see no manual or wiring diagrams for the different possibilities. if it were on the forum it would be easier to make a purchase decision without haveing to wait untill an answer is available or buy it elsewhere.
I guess its just an observation.
power supply (LSR-JN40W3VPWM )
-
ljd10
- Posts: 5
- Joined: Fri Apr 15, 2011 12:02 pm
- Contact:
-
twehr
- Posts: 204
- Joined: Mon Jul 13, 2009 5:08 pm
- Contact:
Re: power supply (LSR-JN40W3VPWM )
Here is the link on this forum for the power supply - pictures, explanation, manual.
viewtopic.php?f=16&t=18
Maybe you did not look in the manuals section of the forum.
viewtopic.php?f=16&t=18
Maybe you did not look in the manuals section of the forum.
-
ljd10
- Posts: 5
- Joined: Fri Apr 15, 2011 12:02 pm
- Contact:
Re: power supply (LSR-JN40W3VPWM )
thankyou! I guess I did look under manuals but not under CNC Stepping motor driver & CO2 Laser Control. I guess I must have been looking for power supply manual. or maybe I was to much of a hurry to get one. I ordered one elsewhere though. thankyou.
Who is online
Users browsing this forum: No registered users and 3 guests