How can i wire induc. proximity sensor to x7 for auto focus?

[typomaniac]

Hey,

i want to upgrade my diy laser which is running with the lo x7 dsp. I bought a LJ8A3-2-Z/BX inductive proximity sensor for using autofocus on my machine.
The sensor has three wires. I know how to wire this to an arduino (6V, GND, Signal) but i do not how how i can use it with the dsp as a switch for the z axis
and therefore for autofocus. How can i wire and use this to the unit?

thanks a lot,
tm

[Techgraphix]

The same... Brown to +V (24V), Blue to GND and Black to signal in (ELZ+)

Kees

[typomaniac]

thank you! Do it put gnd to the switches ground an the x7 or to the power supplys gnd?

thanks again!

tm

[Techgraphix]

You can connect all wires to the controller..

Kees

[Greolt]

I use a three wire sensors (hall effect) for limit on X and Y.

Connect to appropriate connector, 24v, GND, and correct input pin.

Limit input.jpg (53.26 KiB) Viewed 2852 times

[typomaniac]

awesome. Thank you, both!