I have just finished installing K40 upgrade kit (DSP608), downloaded lasercad software and am trying to set up. I go to "select mode", select USB, double click MachName 3 , and click FindCom. At this point "waiting...." flashes across and then nothing....... Any ideas? When I turn on the machine it homes seemingly normally and the laser fires when tested. Any help appreciated!!
Also, is there any sort of manual for the 608? I purchased everything from lightobjects but never received any kind of documentation
Thank!!
Connecting DSP and PC
-
seeigecannon
- Posts: 44
- Joined: Thu Oct 22, 2015 9:35 pm
- Contact:
Re: Connecting DSP and PC
Give these a try. I don't remember where I got them from.Nala wrote: Also, is there any sort of manual for the 608? I purchased everything from lightobjects but never received any kind of documentation
Thank!!
- Attachments
-
- AWC608_Interface.pdf
- (61.37 KiB) Downloaded 215 times
-
- AWC608_Manual.pdf
- (2.93 MiB) Downloaded 321 times
Who is online
Users browsing this forum: No registered users and 5 guests