Engrave with AWC608 controller question ?

[ddefocy]

I was wondering if anybody has seen this effect when engraving ?

When engraving X-horizontal by-directional I get what appears to be delays in marking. This also occurs in the Y-directional as well. The engraving parameters are as follows :

300mm/s
10% power
X-axis by-directional
scan gap 0.15mm

The result is a staggered marking. (see picture)

Thank you in advance for your support.

[Tech_Marco]

Try change the "Pulse Edge" under the manufacturer parameter see if it help
Do the X first, then do the Y later, one by one.


Marco