Lightobject.com Support Forum

It would be nice if a person wanted to order a power supply to see how easy or hard it would be to wire it up to the laser tube and variouse power activation choices. I have looked on the forums but see no manual or wiring diagrams for the different possibilities. if it were on the forum it would be easier to make a purchase decision without haveing to wait untill an answer is available or buy it elsewhere.
I guess its just an observation.

Here is the link on this forum for the power supply - pictures, explanation, manual.

viewtopic.php?f=16&t=18

Maybe you did not look in the manuals section of the forum.

thankyou! I guess I did look under manuals but not under CNC Stepping motor driver & CO2 Laser Control. I guess I must have been looking for power supply manual. or maybe I was to much of a hurry to get one. I ordered one elsewhere though. thankyou.