Trocen 7813 and Lightburn
Posted: Wed Jul 31, 2024 2:33 pm
This may simply be a matter of word use, but in watching some videos by Laser 911 on the Ranger III with the Trocen 7813, they only say the word "Send" when starting to image a file, and not "Start."
These 2 words mean different things in Lightburn, so I would like to know if Lightburn users can click the "Start" button in Lighburn and the laser will start imaging the file.
The Ranger III manual also uses the "Send" wordage:
Page 17 rev 0.6
Sending Files to Laser Machine
Once you have established the connection between the computer and the laser machine, job files
can be transferred.
To do this, click on the “Send” button(LightBurn) OR “Download” button (LaserCAD) located on the
right side of the laser software.
Thanks!
These 2 words mean different things in Lightburn, so I would like to know if Lightburn users can click the "Start" button in Lighburn and the laser will start imaging the file.
The Ranger III manual also uses the "Send" wordage:
Page 17 rev 0.6
Sending Files to Laser Machine
Once you have established the connection between the computer and the laser machine, job files
can be transferred.
To do this, click on the “Send” button(LightBurn) OR “Download” button (LaserCAD) located on the
right side of the laser software.
Thanks!