Change engraving values during job?
Posted: Fri Dec 16, 2016 12:02 am
Hello,
on some forum i read that the x7 / awc608 has an option which enables you to change values like speed and power during a job in order to find out the best values. Is that true and how can i do that? I know how to change them on the controller and restart the job but not how to continue witch changes values.
thanks
tm
on some forum i read that the x7 / awc608 has an option which enables you to change values like speed and power during a job in order to find out the best values. Is that true and how can i do that? I know how to change them on the controller and restart the job but not how to continue witch changes values.
thanks
tm