Setting changed, or system reverted to old settings
Posted: Wed Jun 01, 2016 3:54 pm
I looked through the options tab in LaserCAD and am 90-95% sure I didn't change a thing. I then closed LaserCAD and later reopened through the Corel Macro and noticed that my speed and power % were changed. Upon further testing, my laser now engraves from the bottom instead of the top.
Like I said, there is a small possibility that I changed something but probably did not. Even if I did, there was no way I changed multiple things. So has the system been known to revert back to a previous setting? And if the settings are different, what else might have changed?
Like I said, there is a small possibility that I changed something but probably did not. Even if I did, there was no way I changed multiple things. So has the system been known to revert back to a previous setting? And if the settings are different, what else might have changed?