New R5 DSP Install
Posted: Wed May 11, 2016 12:02 pm
Just installed my new R5 DSP in place of a bad one. I have a 300 x500 mm bed in the machine. How do I go about telling the controller the size of the bed?
is it through the software (RD works) or the front panel? I downloaded the manual it seem to reference what things are not how to configure for the first time.
Any help would be appreciated.
Thanks in advance.
-M
is it through the software (RD works) or the front panel? I downloaded the manual it seem to reference what things are not how to configure for the first time.
Any help would be appreciated.
Thanks in advance.
-M