Lightobject.com Support Forum

Posted: **Thu Jan 28, 2016 6:48 am**

Attached is a screen shot of the simulation. Two squares, 4 circles. The problem is the laser doesn't shut off between objects so my cuts look just like the simulation.
Any advice?
AWC608 controller. Universal 60watt co2 laser

Posted: **Thu Jan 28, 2016 10:19 am**

Check the "TL" or "TH" connection between the DSP card and the power supply. You may have wrong connection

Marco

Posted: **Fri Jan 29, 2016 9:23 am**

Turns out the problem was I had my settings set to glass tube. When I switched it to RF everything fired fine.

Lightobject.com Support Forum

Laser not switching off between cuts

Laser not switching off between cuts

Re: Laser not switching off between cuts

Re: Laser not switching off between cuts