Lightobject.com Support Forum

Hey,

i want to upgrade my diy laser which is running with the lo x7 dsp. I bought a LJ8A3-2-Z/BX inductive proximity sensor for using autofocus on my machine.
The sensor has three wires. I know how to wire this to an arduino (6V, GND, Signal) but i do not how how i can use it with the dsp as a switch for the z axis
and therefore for autofocus. How can i wire and use this to the unit?

thanks a lot,
tm

The same... Brown to +V (24V), Blue to GND and Black to signal in (ELZ+)

Kees

thank you! Do it put gnd to the switches ground an the x7 or to the power supplys gnd?

thanks again!

tm

You can connect all wires to the controller..

Kees

I use a three wire sensors (hall effect) for limit on X and Y.

Connect to appropriate connector, 24v, GND, and correct input pin.

awesome. Thank you, both!