Lightobject.com Support Forum

I have just finished installing K40 upgrade kit (DSP608), downloaded lasercad software and am trying to set up. I go to "select mode", select USB, double click MachName 3 , and click FindCom. At this point "waiting...." flashes across and then nothing....... Any ideas? When I turn on the machine it homes seemingly normally and the laser fires when tested. Any help appreciated!!

Also, is there any sort of manual for the 608? I purchased everything from lightobjects but never received any kind of documentation

Thank!!

Nala wrote: Also, is there any sort of manual for the 608? I purchased everything from lightobjects but never received any kind of documentation

Thank!!

Give these a try. I don't remember where I got them from.