Lightobject.com Support Forum

I av been using lasercad v6.88 on Windows 7 to control the AWC608 DSP in USB mode for a long time and it has worked well. I recently bought a new computer running Windows 10, and I cannot get lasercad to communicate with the DSP.

Tried using both Lasercad v6.88 and 7.77 with no success. I have tried selecting different com channels in lasercad.

Windows shows that the device is not recognized and has been disabled.

Wat can I do?

Thanks.

Try USB driver from the chip maker: FTDI
Suggested by the programmer

Marco

Thanks Marco, it worked!

For anybody else in the same situation, you can download the drivers from here:

http://www.ftdichip.com/Drivers/CDM/CDM ... tified.exe

Thank you for the update. Appropriate!

Marco

laserkid wrote:Thanks Marco, it worked!

For anybody else in the same situation, you can download the drivers from here:

http://www.ftdichip.com/Drivers/CDM/CDM ... tified.exe

I have LaserCAD working fine but Corel is a pain.... posting.php?mode=quote&f=8&p=14543#