Lightobject.com Support Forum

Hello, I have a mach 3 home built laser system running gecko servo drives and servo motors. Is your dsp laser controller compatible with servo motors?

thanks

Scott

Yes, it does. Go to the manual section and down the manual.

Thanks Marco.

I have read through the manual. I think the manual makes mention that the motion controller board "could" be used to control 2 motors per axis. I have a gantry that uses two motors for the x axis, each driving its own ball screw, one is set as a slave. The y axis only uses one motor. Do you know if this can be done with the motion controller board?

Scott

I was told that the support can support two X driver and one Y