Lightobject.com Support Forum

Hello,
I need a help. I´m installing new DSP controller in my DIY laser 50W. I have a problem with the configuration in Corel X4. I can´t start the configuration, because the system is asking for an input code (NO.2): ´machine locked, please input the code´. Where I can find this system code?
Thanks
Petr

Did you buy the card from us? What is your order #?

Hallo Marco,
yes, I bought this controller in april, order #76474B. SN A#PH#20103.
Thanks
Petr

Code sent

Hello Marko,
the numeric code is OK
Thanks
Petr