Lightobject.com Support Forum

Posted: **Tue Jun 23, 2015 7:52 pm**

I'm upgrading from an AWC608 to the x7. It appears the function of OUT1 is inverted, or is it me?

Posted: **Wed Jun 24, 2015 1:26 pm**

geotek wrote:I'm upgrading from an AWC608 to the x7. It appears the function of OUT1 is inverted, or is it me?

I think it's inverted too - I had to change my supervisor controller's code to compensate, so yes, it appears to be inverted.

/Mitch.

Posted: **Wed Jun 24, 2015 1:52 pm**

Thanks. I use the Out1 to control a compressed air solenoid and the exhaust blower. The blower operates during cutting and turns off 1 minute after cutting. Helps keep noise down in the shop.

Lightobject.com Support Forum

Out1 function inverted on LOx7?

Out1 function inverted on LOx7?

Re: Out1 function inverted on LOx7?

Re: Out1 function inverted on LOx7?