Lightobject.com Support Forum

Hi Marco and others.

I have just purchased 3 of your drivers and a numbers of other bits and bobs its all turned up and in good condition I also would like to thank you for getting it to me so quick.
Anyway was hoping you could help me a little more just don't want to make any mistakes and kill the controller.
I have the following pins on the Driver you supplied me.

PLS+
PLS-
DIR+
Dir-
ENA+
ENA-

Following Pins on the MP6535

Dir
Pul
+5V

So what do you think = what lol.

MPC 6535 Dir =
MPC 6535 Pul =
MPC 6535 5v =

Anyhelp is much appreciated.

Willy AKA Sean

I'll post more information later. Following is a manual of MC6515, Setup manual of my DSP card (written by Tim), and a basic connection diagram of the card