Looking for some advice and assistance-SOLVED
Posted: Wed May 27, 2015 10:51 am
My leetro motion controller MPC6525 (apparently the same as 6515) stopped working in the middle of a job. After some research online I arrived at Lightobject and purchased DSP Controller kit (708 and LO-X7 display)
Now I am trying to install and convert to the new DSP with a wiring diagram that came with it. It really does not provide a conversion and I am concerned I will short something out if I choose the wrong wire...
I have a 600/900 80W cutter with servo motors not stepping motors. Attached pic of panel with cover off old DSP.
If anyone out there has already done this with success, I would very much appreciate some (positive) advice.
Now I am trying to install and convert to the new DSP with a wiring diagram that came with it. It really does not provide a conversion and I am concerned I will short something out if I choose the wrong wire...
I have a 600/900 80W cutter with servo motors not stepping motors. Attached pic of panel with cover off old DSP.
If anyone out there has already done this with success, I would very much appreciate some (positive) advice.
- current guts
- IMG_1869.JPG (292.39 KiB) Viewed 1598 times