Engraving BMP photos always produce inverse , why ?
Posted: Tue Feb 17, 2015 6:01 am
Why i always get inversed photo when i want a engrave some BMP photos using image dither ( in lasercad ) ?
If i inverse it still get inversed photo
!!
I don`t really understand that
If i use rastr 1.0 mm - ok .....
raster 0.3 ------ inversed
raster 0.5 ------ inversed
raster 0.7 ------ inversed
raster 0.9 ------ inversed
thx for hlp
dave
If i inverse it still get inversed photo
!!I don`t really understand that
If i use rastr 1.0 mm - ok .....
raster 0.3 ------ inversed
raster 0.5 ------ inversed
raster 0.7 ------ inversed
raster 0.9 ------ inversed
thx for hlp
dave