Lightobject.com Support Forum • new lasercad program where goes the air switch for cutting?

Page 1 of 1

new lasercad program where goes the air switch for cutting?

Posted: Sun Feb 08, 2015 2:29 am

by waltfl

hi marco
I discovered that the new lasercad program has a selection for air switch very nice but where does the connection goes??
thanks
waltfl

Re: new lasercad program where goes the air switch for cutti

Posted: Mon Feb 16, 2015 6:48 pm

by Tech_Marco

It is for LO-X7 DSP card control. There is no change on the AWC608 even with new software

Marco

Re: new lasercad program where goes the air switch for cutti

Posted: Tue Feb 17, 2015 1:57 am

by waltfl

hi marco
thanks I thought so.
greetings
walt

Tech_Marco wrote:It is for LO-X7 DSP card control. There is no change on the AWC608 even with new software

Marco