Lightobject.com Support Forum

Hey Marco,

I have been using a new AWC708C for about a week, I just tried to boot the machine up and it homes but ignores both the X axis and Y axis homing switches. It stalls the steppers and can not finish booting.

I checked all the wiring and everything is ok there.

Is the controller blown?

Double check the parameter setting to make sure the Limit switch is set to 'negative' triggering
Blown?? How could it be?

Marco

Checked parameters and they are fine.

Found out if I hit stop when it tries to home I can continue into a job.

Everything else works fine. It is just ignoring the inputs from both the X and Y axis.

I have the same problem, still working on it, New X7 with new table, found bad micro switch, no help.
Anybody figures it out let me know I'll do same.

Woody