Page 1 of 1
Lasercut software.
Posted: Thu Dec 04, 2014 11:27 am
by cmdr114b
Can anyone tell me where I can buy Lasercut 5.3 and its dongle, preferably in the UK.
And am I right in assuming that this software will drive the LightObjects DSP controller that I have just purchased.
Thanks
John
Re: Lasercut software.
Posted: Thu Dec 04, 2014 11:39 am
by Tech_Marco
John:
AWC608 doesn't use LaserCut v5.3 but LaserCAD only without dongle needed. If you buy AWC608 from us, we will provide software for you. LaserCut (Leetro 6515 or 6535 DSP) is NOT compatible with LaserCAD
Marco
Re: Lasercut software.
Posted: Thu Dec 04, 2014 12:47 pm
by cmdr114b
Hi Marco,
I received my controller in the full upgrade kit that I bought from you which arrived yesterday, but there was no software in the package.
Can I download it from you?
John