Page 1 of 1
Re: Z table wiring
Posted: Thu Aug 07, 2014 9:52 am
by Tech_Marco
You need a motor driver like the 2M415 to drive the motor. Same connection like the XY stage
Marco
Re: Z table wiring
Posted: Thu Aug 07, 2014 2:44 pm
by NickWL
Mine goes up and down (albeit the wrong way round) via the DSP control panel - very handy too!
Re: Z table wiring
Posted: Sat Aug 09, 2014 10:22 pm
by Tech_Marco
Press "U/Z" to enable movement on Z and U axial
MW
Re: Z table wiring
Posted: Wed Aug 13, 2014 3:59 pm
by Tech_Marco
It is better you use the little motor controller to control the Z table. It take too much work to drive it by DSP as you need to install a limit switch for the Z table.
Also, by using the DSP, you don't have to use the SC04 controller board
I will say stay with the SC4 board, it is easier to take control than the DSP
Marco
Re: Z table wiring
Posted: Thu Aug 14, 2014 2:25 am
by NickWL
I drive my z-table from the DSP without a limit switch - no problem at all!
Nick