New X motor for k 40
Posted: Wed Aug 06, 2014 1:47 pm
I ordered and received a new motor and the wire colors are different. Which wires go to which ?
Can you give us Pics?
It may help resolve the issue.
Lightobject.com Support Forum
California (Sacramento) CO2 laser machine support
https://lightobject.info/
New X motor for k 40
Page 1 of 1
Re: New X motor for k 40
Posted: Sun Dec 14, 2014 3:14 pm
Re: New X motor for k 40
Posted: Tue Dec 16, 2014 2:04 pm
In your shoes I would connect up the wires according to their position as they come out of the motor. This should give a better than 50-50 chance.
Then, knowing that no damage is going to result I'd dig out a stepper-motor internal wiring diagram and start swapping single pairs of wires.
Whenever I got any kind of movement at all I'd leave the last pair alone and swap the others.
Might work, might not, but that's what I'd do!
Nick
Then, knowing that no damage is going to result I'd dig out a stepper-motor internal wiring diagram and start swapping single pairs of wires.
Whenever I got any kind of movement at all I'd leave the last pair alone and swap the others.
Might work, might not, but that's what I'd do!
Nick