DSP Stopped working
Posted: Thu Jul 31, 2014 5:34 pm
While uploading a file to the controller Lasercad crashed, now my dsp stopped working entirely.
It will start up just fine, but all the settings on it reset when it turns on, including the network settings, and after it moves to home and back none of the motors will move, nor will the laser fire, I can no longer communicate with the controller from lasercad, formatting from the lcd controller does nothing.
Basically nothing is working after that lasercad crash, and I can't figure out what is going on. Anyone have any ideas, or am I totally screwed here?
It will start up just fine, but all the settings on it reset when it turns on, including the network settings, and after it moves to home and back none of the motors will move, nor will the laser fire, I can no longer communicate with the controller from lasercad, formatting from the lcd controller does nothing.
Basically nothing is working after that lasercad crash, and I can't figure out what is going on. Anyone have any ideas, or am I totally screwed here?