Page 1 of 1
Re: DSP upgrade, stepper motor wiring confusion
Posted: Thu Jul 31, 2014 7:21 am
by Tech_Marco
You can use any wire. Not necessary of using Cat5. I was using Cat5 because it came in handy and it can reduce effect from electromagnetic interference.
Marco
Re: DSP upgrade, stepper motor wiring confusion
Posted: Thu Jul 31, 2014 8:37 am
by Tech_Marco
Yes. It is troublesome trying to find out the pin from the optical sensor, even though the DSP support it
So, I would rather to use a regular limit switches for that purpose
You can just remove that part out from the stage as it is useless. I got a bunch of that module and if anyone want it, just send me shipping cost and I can mail it to you if needed that
Marco