Replacing LeadCNC Controller
Posted: Mon Jun 30, 2014 9:41 am
Marco, I am getting fed up with the LeadCNC controller that came on my GWieke Storm 500 machine 2 months ago. It is marked LNC240A but I can find nothing on it. Does NOT require a dongle and the software version is LaserCutEngrave 3.3.
Input voltage is 24 VDC, has standard Leadshine Stepper Drivers and the Laser power supply has terminal marked: L1,FC,AC,AC and the other terminals marked: G (nc), P, L,G,IN, 5V (nc)
My question is will your 608 controller replace this and be an improvement? I have already reviewed the software and I love what it can do. Thank you!
Input voltage is 24 VDC, has standard Leadshine Stepper Drivers and the Laser power supply has terminal marked: L1,FC,AC,AC and the other terminals marked: G (nc), P, L,G,IN, 5V (nc)
My question is will your 608 controller replace this and be an improvement? I have already reviewed the software and I love what it can do. Thank you!