custom HMI possible?
Posted: Fri Oct 11, 2013 1:45 pm
Hey all,
on leetro controllers the lcd panel (the Human Machine Interface) is talking to the controller via a serial bus using the modbus protocol. All the commands are even documented so you can develop custom HMI's.
Does the AWC608 also use modbus for communication? If so, is there any documentation on commands and addresses? I would be very interested to make a custom HMI to control the machine as I can then add controls for some special functions we have in our machine. In this way it would also be possible to connect a second HMI so you can control the machine from both sides.
on leetro controllers the lcd panel (the Human Machine Interface) is talking to the controller via a serial bus using the modbus protocol. All the commands are even documented so you can develop custom HMI's.
Does the AWC608 also use modbus for communication? If so, is there any documentation on commands and addresses? I would be very interested to make a custom HMI to control the machine as I can then add controls for some special functions we have in our machine. In this way it would also be possible to connect a second HMI so you can control the machine from both sides.