new peogramm v. 6.71 does not open all files from v. 6.41
Posted: Tue Jul 30, 2013 2:22 am
hi all
does anybody experience the same problem? here it comes
I had to move in a new house and setup my converted K40 station again and now I thought I install the latest program version with the OS upgrade.
after this was finished I try to start some work with files what I did before with the older version and some of the files I can not even open or nothing shows up on the screen. another scenario is that if I select a whole work and try to move it a bit the program comes not responding and I have to close the program.
the next thing is on some older files who did work perfectly before the engraving part makes double image just slightly offset, it does not happen with a new file created with the new version .
now the question is what is the problem?
maybe marco can look in to it.
thanks for the help
greetings
waltfl
does anybody experience the same problem? here it comes
I had to move in a new house and setup my converted K40 station again and now I thought I install the latest program version with the OS upgrade.
after this was finished I try to start some work with files what I did before with the older version and some of the files I can not even open or nothing shows up on the screen. another scenario is that if I select a whole work and try to move it a bit the program comes not responding and I have to close the program.
the next thing is on some older files who did work perfectly before the engraving part makes double image just slightly offset, it does not happen with a new file created with the new version .
now the question is what is the problem?
maybe marco can look in to it.
thanks for the help
greetings
waltfl