mistake in the 3-axis stepper motor controller : Page10
Posted: Fri Dec 11, 2009 12:51 pm
Since there are no page numbers, i just counted.
In the Mach3 configuration page where you describe the setting of the X++, X-- ect limits, all the parallel port pins are shown "0". Since you do describe that the limit swicthes can be connected to the board, should'nt they have the correct parallel port pin numbers ??
In the Mach3 configuration page where you describe the setting of the X++, X-- ect limits, all the parallel port pins are shown "0". Since you do describe that the limit swicthes can be connected to the board, should'nt they have the correct parallel port pin numbers ??