Cutter not always returning to home after a job
Posted: Sat Jun 15, 2013 6:40 pm
Sometimes it happens sometimes it doesn't - my cutter doesn't always return to the origin / home when the cutting job is complete. The option for doing so is set up at a machine level, so I'm not sure what I'm doing wrong. For instance, the last job I ran three times. It would go back to about 1 inch to the right of the origin. And each subsequent job was staggered an inch to the left. So the 7th job would be staggered 7 inches.
Any thought on what might be happening here?
Any thought on what might be happening here?