Analog output on newest dsp
Posted: Sun Jun 09, 2013 3:02 pm
Hi, Im currently converting my k40 machine.
This machine has an analog ps for the laser, on the productpage it says the current dsp, as shown on the picture has "* Real time power control: PWM and analog", how can I set my board to realtime analog output, and on which pin? (Not the solution on which you use a potmeter).
Also where can I find this in the manual?
Anyone any Idea?
Jjshortcut
This machine has an analog ps for the laser, on the productpage it says the current dsp, as shown on the picture has "* Real time power control: PWM and analog", how can I set my board to realtime analog output, and on which pin? (Not the solution on which you use a potmeter).
Also where can I find this in the manual?
Anyone any Idea?
Jjshortcut