MPC6515C to DSP conversion questions
Posted: Mon Mar 11, 2013 10:56 am
Hello,
I just got in a G-Weike 80watt LC6090 laser. It has the MPC65150 controller board and required LaserCut5.3 software. I've never seen such terrible software. Total garbage even when I can get it to work.
I read a post at a different forum recommending the LightObject board.
Is there anything else I would need other than the LSR-4XDSPV2012?
It looks like it's almost plug and play with the same connectors and everything. Seems too good to be true. I can handle just about any complicated installation but I'd like to know what I'm getting into first.
The video on the product description is not available. Does anyone have a working link?
Here is a closeup of the MPC6515C
Entire controller area
I just got in a G-Weike 80watt LC6090 laser. It has the MPC65150 controller board and required LaserCut5.3 software. I've never seen such terrible software. Total garbage even when I can get it to work.
I read a post at a different forum recommending the LightObject board.
Is there anything else I would need other than the LSR-4XDSPV2012?
It looks like it's almost plug and play with the same connectors and everything. Seems too good to be true. I can handle just about any complicated installation but I'd like to know what I'm getting into first.
The video on the product description is not available. Does anyone have a working link?
Here is a closeup of the MPC6515C
Entire controller area